AudioControl LC2i PRO
The LC2i PRO joins the ranks of AudioControl’s most popular active line output converter, the LC2i. Whether you are adding a sub or planning a full system, it gets the best possible signal from your factory sound system to your amplifiers. Load selection switches make OEM integration easy even with the most finicky factory systems, and installer friendly trigger modes allow turn-on via GTO™ Signal Sense (DC offset), audio sense or remote 12 volt input. AccuBASS® compensates for factory bass roll-off and the included ACR-1 controls your sub level.
Key Features
- Active Speaker Level Inputs: Two channels, up to 40V input handling
- Fixed and Variable Outputs: With discrete level controls
- AccuBASS®: Correction of bass roll-off
- Load Selection Switch: 20 Ohm, 60 Ohm or 20 kOhm
- GTO™ Signal Sensing: Plus audio sense and 12V remote in
- Ground Isolation Switch: Helps eliminate noise
- ACR-1 Dash Remote Included: Sub level control from the driver seat
- Compact Design: Easy installation
Technical Specifications
- Speaker Level Input: 1 (2 channels)
- Maximum Speaker Level Input: 40 Vrms / 400 W (20 kOhm setting)
- Input Impedance (selectable): 20 Ohm, 60 Ohm, 20 kOhm
- Preamp Outputs: 2 (2 channels main, 2 channels bass)
- Maximum Output Level: 9.5 Vrms / 13V peak
- Output Gain: ±12 dB
- Output Impedance: 150 Ohm
- THD: 0.01%
- Signal to Noise: >110 dB
- Frequency Response: 20 Hz – 50 kHz ±1 dB
- Control: Remote In / GTO™ Signal Sense / Audio Sense, 12VDC remote out (always active when unit is on)
- Current Draw: 200 mA
- Recommended Fuse: 1A
- Dimensions: 6.9″ L x 3″ D x 1″ H (including speaker connectors)
- Weight: 0.34 kg (0.75 lbs)
- In the Box: LC2i PRO, ACR-1, 20′ phone cable, speaker and power connectors, manual
The clean, powerful signal you need to take a factory-based system from good to great.
