Vibe BLACKAIR10D2S-V3
The Vibe BLACKAIR10D2S-V3 is the 10″ in the BlackAir flat series – the bigger sibling of the flat 8″ and the choice when you want more output and deeper bass but still have almost no depth to give. It fits in just 76 mm, and it is a proper 10″ underneath: a full 346 cm² cone, 300W RMS and a dual 2 Ohm voice coil that wires to any amp.
Key Features
- Ultra Shallow: Only 76 mm (3″) mounting depth for installs a normal 10″ will not go near
- Bigger Flat Sub: 346 cm² cone area moves far more air than the flat 8″ (214 cm²)
- Reaches Lower: 36 Hz resonance with response down to 30 Hz – bass you feel in the seat
- Dual 2 Ohm Voice Coil: 1 Ohm in parallel, 4 Ohm in series or independent connection to two channels
- Coil Built for the Power: Four-layer copper coil on a 2.4″ aluminium former pulls heat away under sustained power
- Small Box or None: High total Q (0.76) suits a small sealed box, free-air or infinite baffle mounting
- Solid Build: Steel basket with push terminals
Technical Specifications
- Type: Passive subwoofer (shallow mount)
- Speaker Size: 10″ (274 mm)
- RMS Power: 300 W
- Peak Power: 900 W
- Impedance: Dual 2 Ohm
- Sensitivity: 85 dB
- Frequency Response: 30 Hz – 1 kHz
- Xmax: 7.1 mm (0.28″)
- Fs: 36 Hz
- Qts: 0.76
- Vas: 14.4 L (0.51 cu.ft.)
- Mounting Depth: 76 mm (3″)
- Mounting Diameter: 230 mm (9″)
- Recommended Enclosure: 0.7 – 1.8 cu.ft. sealed or free-air
- Recommended Amplifier: POWERBOX400.1M
If you have a shallow space and want the most bass you can get out of it, the BLACKAIR10D2S-V3 is the one.
